Selection Guide Cam Clutch
one-way clutch －Cam Clutch －
This is a mechanical one-way clutch. It uses multiple cams arranged so that there is no backlash.
- ・Machined with an advanced specially-designed machine for the highest level of accuracy.
- ・Our unique heat treating process gives these cams excellent durability.
- ・Secure actuation and high reliability
Single Revolution clutch －SR Clutch －
The SR Clutch is lever-operated to impart one turn or an integral number of turns from the outer race (drive) to the inner race (load).
- ・Excellent responsiveness
- ・Secure engagement
- ・Consistent stopping position
- ・Exceptional durability
Cam clutches engage and overrun due to the rotation speed and direction difference between the inner and outer rings.
Cam clutches continuously and alternately engage and overrun through reciprocating motion at a constant angle to the outer race for intermittent feeding.
Used to prevent the reverse rotation of rotating shafts. Cam clutches continue overrunning during forward rotation of the shaft, and when rotation is about to reverse, they engage to prevent this.
Multi type
MZ Series
Multi type
MZ-G Series
For overrunning
MG Series
Small diameter hub
PB Series
Compact
200 Series
For low speed, light load applications
LD Series
For high-speed overrunning of the outer race
MR Series
For medium load applications
ML Series
For indexing applications
MI Series
Low-speed indexing applications with large indexing angles
MI-S Series
For high-speed indexing applications
MX Series
For backstop applications with shock loads
MA Series
For high-speed overrunning and backstopping of the inner race.
BR,BR-P Series
For medium-speed overrunning and backstopping of the inner race
MG-R Series
For low-speed overrunning and backstopping of the inner race
BS Series
Most compact
BB Series
Indirect type
SR Series
Sizing Guidelines
- ・For loads with small inertial force
- ・For operating speeds slower than 100 rpm
- ・Shaft Bore Diameter φ15,φ20,φ30,φ40
- ・Allowable Torque 2.5～40kgf･m
Direct type
SRD Series
Sizing Guidelines
- ・For loads with heavy inertial force and operating speeds faster than 100 rpm
- ・Shaft Bore Diameter φ15,φ20,φ30
- ・Allowable Torque 2.5～15kgf･m
