Technical Data Linear actuator Linispeed Jack Handling
This section describes the general handling of Linispeed jacks.
For details, please refer to the instruction manual included with the product.
Operation
- ・When selecting a jack, select a jack with sufficient capacity to ensure that both the working load (static and dynamic) and shock load do not exceed the allowable thrust, and that the safety factor is considered.
- ・The operating temperature range indicates that the surface temperature of the reducer unit, including ambient temperature, is -10 to 90°C with the jack in operation. When measuring temperature, check the surface temperature of the jack input shaft. Be sure all the rotating parts have completely stopped before proceeding to measure.
- ・The allowable input rotation speed is 3000 rpm Also, use the product below the maximum allowable input capacity.
- ・The number of jacks that can be connected in a single line is limited by the strength of the shaft. Please confirm the allowable input shaft torque.
- ・Be sure to check the required input torque at the starting efficiency when the equipment is just turned on.
- ・If operating in freezing temperatures, a change in viscosity may reduce the efficiency of the oil. Set the drive unit so as to accommodate this change.
- ・Since the screw jack has high efficiency, a brake mechanism that exceeds the holding torque is necessary.
- ・Be certain that the jack rating exceeds the maximum possible stroke. Usage that exceeds the specified jack stroke range may lead to jack damage. Linispeed Jack is equipped with a retaining mechanism. This is designed to prevent the screw shaft from falling out during installation.
- ・Never approach or touch the input or screw shaft during operation. Doing so may cause injury.
