Tsubaki Products

Technical Data 　High-speed lifters 　Zip Master 　Handling

Checking the item upon arrival/Transporting/Installation

This section describes the general handling of ZIP MASTER.

For details, please refer to the instruction manual included with the product.

Inspection upon Receipt of Product

When you receive the product, check that: If you have any problems or questions, please contact the store where you purchased the product.

・Check the nameplate to verify the model number (1), manufacturing number (2), and drawing number (3) match the requested product (see Fig. 1).
・All accessories are provided.
・No parts were damaged during transport.
・No screws or nuts are loose.

(Fig. 1)Reading the nameplate

Include the model number (1), manufacturing number (2), and drawing number (3) when contacting Tsubaki with any problems or questions.

Mounting

⚠ Danger	Be sure to install the product on a strong base and fix it securely. The product may fall over, drop, or operate abnormally, which may result in injury.

⚠
Danger

Be sure to install the product on a strong base and fix it securely.

The product may fall over, drop, or operate abnormally, which may result in injury.

1. Handling in packaged condition

Please handle with care during transportation to avoid bumping or dropping.

(1) Do not work alone when transporting heavy objects.
(2) When storing it, please keep it in a horizontal position.
(3) Do not step on the packaging.
(4) Do not place heavy items that may deform the packaging or items that are subject to concentrated loads.

2. Mounting

(1) Please make sure that the installation surface is sufficiently rigid and remains horizontal.

(2) When unpacking and lifting the main unit, first disassemble the packing box, then hang a nylon sling or other lifting device on the eyebolts at the top of the main unit and stand the main unit up.
Lift the main unit while it is still standing and move it to the installation position.
※For details, see the figure on the right.

⚠ Danger	・When lifting the main unit, be sure to use the eyebolts on the top of the main unit. Since the center of the main unit has a hollow structure, hanging this part may damage the built-in equipment and lead to a serious accident. ・The installation site of ZIP MASTER should be rigid enough to allow proper installation, and the base or foundation should be sufficiently strong enough to maintain the pull-out strength of the mounting bolts even when the maximum load is applied. Also, use four M16 (strength grade 10.9 or higher) mounting bolts with a thread length of 25 mm or more.