Technical Data  Clutches  Handling

MI-S Series  Handling Precautions

  • 1. Sprockets, gears, etc. to be mounted on the outer race should be inlet with the inner circumference E dimension of the outer race (see here) and securely attached with bolts of strength category 10.9 to the tapped holes on the outer race end face. Tolerance of f7 is recommended for the inlet section.
  • 2. The recommended shaft tolerance is h6 or h7.
  • 3. Always use parallel keys and keep a clearance between the top of key and keyway. Use JIS B1301-1996 (new JIS) parallel keys (standard type). Make sure that there is no lateral play between the key and keyways. Install an end plate on the face of the inner race
  • 4. When inserting the shaft, apply pressure only to the face of the inner race only.
  • 5. For more information on lubrication and maintenance, click here.