Technical Data Linear actuator Linispeed Jack Allowable overhang load
Allowable overhang load
When installing a sprocket, gear, or belt on the input shaft, use the following formula to verify that any overhang load applied to the shaft falls within the allowable OHL.
Allowable O. H. L. ≧ T×f×Lf R
O.H.L.：Overhang load N
T：Input torque N・m
f：Transmission element factor
Lf：Factor by load acting position
R：Pitch circle radius of sprocket, gear, V pulley m
L：Load acting position
Q：Length of shaft
Table 2 Transmission element factor (f)
| Chain | 1.00 |
|---|---|
| Gear, toothed belt | 1.25 |
| V-Belt | 1.50 |
| Flat belt | 2.50 |
Table 1 Input shaft allowable overhang load
| SJ015H | SJ030H | SJ050H | |
|---|---|---|---|
| Allowable O. H. L. (N) |
830 | 1280 | 1760 |
Table 3 Factor by load acting position (Lf)
| L/Q | Below 0.5 | 0.75 | 1 |
|---|---|---|---|
| Lf | 1 | 1.5 | 2 |
