Technical Data Reducers Gear Reducer for Servo Motors TERVO Handling
This section contains general information regarding the handling of the TERVO HMTK, GMTK, SWJMK, SWMK, EWJMK, and EWMK Series.
For more information, see the instruction manual provided with the product.
Inspection upon Receipt of Product
Check the following items upon receipt of your reducer. Contact Tsubaki representative if any defects are found, or if you have any questions.
- (1) Verify that the specifications on the nameplate match those requested. Pay special attention to the shaft arrangement and rotational direction. Check this against the position of the input and output shafts, oil gauge and plugs.
- (2) All accessories (such as pressure vent) are provided.
- (3) No parts were damaged during transport.
- (4) No screws or nuts are loose.
1. Reading the nameplate
When inquiring, please provide the following information: (1) TYPE (Model), (2) RATIO (Reduction ratio), (3) MFG. No. (Manufacturing No.), and (4) DRAWING NO. (Drawing No.).
2. Model No. Designation
Make sure the model of the unit matches your order.
