Technical Data  Reducers  Gear Reducer for Servo Motors TERVO Handling

This section contains general information regarding the handling of the TERVO HMTK, GMTK, SWJMK, SWMK, EWJMK, and EWMK Series.

For more information, see the instruction manual provided with the product.

Transporting

• (1)Exercise caution to prevent the dangerous situations arising from this product falling down or rolling over during transport. If suspension fixtures are present, be sure to use the suspension fixtures with the reducer and ensure that the fixtures are not loose.
  However, once the device is installed, avoid attaching the suspension fixtures to the device and then raising up the entire device by the suspension fixtures. Doing so may lead to damage to the suspension fixtures and to injuries and equipment damage arising from the product falling down or rolling over.
• (2)Prior to suspending the reducer, determine its mass by checking information such as the nameplate, packaging, external diagram, or catalog. Then, do not suspend the reducer if it meets or exceeds the rated load of the suspension fixtures. Doing so may lead to damage to the suspension fixtures and to injuries and equipment damage arising from the product falling down or rolling over. Also, do not place your hands in the terminal box to lift up the product. Doing so may cause the terminal box to fall out.
• (3)If the packaging is a wooden box, the product will be unstable if you use a forklift to scoop up the box from underneath. Instead, wrap a belt around the box and affix this belt to the forklift when raising up the product.
• (4)When transporting the product, insert eye bolts or similar objects into the installation taps on the sides of the housing to suspend the product in a balanced manner.