Worm Power Drives 　Major Specifications

Transmission Capacity Table

Reduction ratio	Input 1750　r/min			Input 1450　r/min			Input 1150　r/min			Input 950　r/min			Input 500　r/min			Input 100　r/min			Estimated Mass kg
	Input kW	Output torque		Input kW	Output torque		Input kW	Output torque		Input kW	Output torque		Input kW	Output torque		Input kW	Output torque
		N･m	{kgf･m}		N･m	{kgf･m}		N･m	{kgf･m}		N･m	{kgf･m}		N･m	{kgf･m}		N･m	{kgf･m}
50	2.75	584	59.6	2.64	661	67.5	2.43	748	76.3	2.23	812	82.9	1.30	828	84.5	0.31	830	84.7	39

・If the unit is to be run continuously between 1750 and 950 r/min for more than two hours, you must consider the thermal rating. Refer to the thermal rating factor on the technical data.

Solid output 　Allowable Radial Load

N	{kgf}
11525	1176

Standard package

Reducer	Lubrication System	Oil bath (shipped filled)
		Daphne Alpha Oil TE260
	Keyway	New JIS standard, normal grade 　JIS B1301-1976（Key is supplied with solid shaft models. ）
	Paint specifications	Munsell 2.5G6/3 (green)
		Primer: lacquer primer 　　Finish coat: lacquer-based paint
	Rust Proofing Specifications	Rust proof effective for 6 months when stored indoors (after shipping).
		Outside: rust-proofing grease 　　　Inside: sealed after lubrication oil is filled
Ambient conditions	Installation	Indoors
	Ambient Temperature	-10℃～50℃
	Ambient Humidity	95% or less (no condensation)
	Altitude	No more than 1,000 m above sea level
	Atmosphere	Area must be free of corrosive and explosive gases, steam, condensation, and have little or no dust.
Installation direction		Horizontal or vertical